2N EasyGate - User Manual - Manual (Page 30)

25
8.3.4. GSM & SIM Parameters
GSM operator lock
Function No.: -
Provider blocking is set by manufacturer in EasyGate. If EasyGate is blocked to a
GSM provider, no other GSM provider's SIM card can be used. If an
unacceptable SIM card is used, the GSM modules does not registered to GSM
and the GSM network LED flashes quickly on the EasyGate panel.
CLIR - incognito
Function No.: 41
Sets the calling line identification restriction (CLIR) for outgoing calls from
EasyGate. Attention, before enabling it is necessary to activate this feature by
GSM operator, otherwise outgoing calls can be rejected by GSM network.
Setting options:
-According to provider - depending on how the function is selected
in the GSM network
-Activation - ID is not sent.
-Suppression - ID is always sent.
Default setting: According to provider
Roaming enable/disable
Function No.: 42
You can make EasyGate work even if it is registered to a foreign GSM network.
Setting options:
-Disable -The GSM module logs out of a foreign network and attempts to
register again in within 5 minutes.
-Enable -EasyGate works in any GSM network.
Default setting: Disable
Incoming calls enable
Function No.: 43
With this parameter you can reject all incoming calls.
Setting options:
Enable - Incoming calls ring on the telephone line.
Disable - Incoming calls are rejected.
Default setting: Enable
8.3.5. Service Parameters
Hardware version
Function No.: -
EasyGate hardware version - for information only (cannot be modified). Must be
used for communication with the manufacturer.
Firmware version
Function No.: -
EasyGate firmware version - EasyGate central processor program version. The
manufacturer can issue upgrades to extend functions. To load new firmware into
EasyGate use the Upgrade function. Keep communicating with the manufacturer.