2N EasyGate - User Manual - Manual (Page 24)

19
8.3. Parameter Tables
All programmable parameters are listed in this section. Each parameter is
accompanied with the unit used, function number (if available) for programming via a
telephone line, description of EasyGate's behavior, setting options, setting step and
default (initialization) value.
8.3.1. Telephone Line Parameters
Type of dialing
Function No.: -
Select the dialing type to be received by EasyGate from the PBX or telephone
set. EasyGate accepts only the selected type of dialing, ignoring the others.
Setting options:
DTMF -EasyGate receives tone dialing only.
Pulse -EasyGate receives pulse dialing only
Default setting: DTMF
Time to dial [s]
Function No.: -
Timeout during which EasyGate waits for further digits to be dialed. It starts to
establish connection when this timeout passes.
Setting options: 1-15 s
Setting step:
1 s
Default setting: 5 s
Dial tone
Function No.: -
This tone is generated after Off-Hook in case EasyGate is ready to accept
dialing.
Setting options:
Continuous -EasyGate generates continuous dial tone.
Interrupted -EasyGate generates interrupted tone with 320/640 ms timing.
Default setting: Continuous
Tone after disconnection
Function No.: -
If the remote subscriber hangs up first, the EasyGate subscriber can hear the
tone selected here.
Setting options:
Busy -EasyGate transmits the busy tone upon call end.
Permanent -EasyGate transmits the permanent tone upon call end.
Default setting: Busy tone
Minimal On Hook [ms]
Function No.: -
The minimum line current discontinuation that EasyGate evaluates as hang-up.
Setting options: 100-1500 ms
Setting step:
100 ms
Default setting: 500 ms