2N EasyGate - User Manual - Manual (Page 15)

10
5.3. FAX call (only on models with fax converter)
EasyGate with fax converter has ability to send and receive fax messages using
analog fax Group 3 connected to telephone line. The fax communication service must
be registered with your network operator.
Sending a fax message
Prior to destination number must be dialed code *01*, to inform the Gateway, that the
following call is a fax call.
Receiving a fax message
It is recommended to activate separate fax number on your SIM card –
multinumbering scheme. Fax messages should be routed to this number, the
message will be than received as fax message.
If the fax number is not activated, the call from analogue network is not detected as
fax call and is routed via the analogue channel of GSM network and the call is not
successful. In this case it is possible to activate fax engine in the gateway to receive the
next call as fax call. The code *9901# must be send to the gateway to prepare it to
receive a fax call. After receiving the fax this setting is suspended.
5.4. Automatic Call ("BabyCall")
If the BabyCall function is enabled, a pre-programmed period of time is counted down
after off-hook. If you do not start dialing within this timeout, EasyGate signals dialing
end and starts establishing a call to the pre-programmed number automatically – from
now on EasyGate behaves as if a standard outgoing call had been established. Any
dialing during the BabyCall timeout cancels this function and a standard outgoing call
can be made.
5.5. Tariff pulses 16 or 12 kHz
EasyGate has tariff pulse transmitter. You can use tariff pulses for outgoing call
pricing. EasyGate offer pseudotariff only – tariff metering doesn’t correspond to real
price of call, tariff pulses are transmitted according to programmed parameters and call
duration. You must program specific parameters in call table to set tariff metering for
different prefixes of dialed numbers.
You can also program EasyGate to transmit tariff pulses as call connect/disconnect
signaling if your PBX cannot receive telephone line polarity change signaling.