Module mounting – 2N Helios IP Force User Manual
Page 26
26
1.
2.
3.
a.
b.
c.
4.
5.
6.
7.
a.
b.
c.
8.
9.
Module mounting:
Switch off the intercom.
Remove the front panel from the intercom.
According to your model
If you are mounting the switch into a two-nameplate model, demount the
button PCB (1) and remove the right-hand bottom spacer (there are four
PCB fitting spacers altogether).
If you are mounting the switch into a keypad model, take the keypad out of
the holder. Demount the right-hand keypad holder - beam with a pin (8) –
remembering its position. Demount the right-hand bottom spacer. Do not
disconnect the keypad cable!
If you are mounting the switch into a model other than the two ones
mentioned in items 3a and 3b above, remove the right-hand bottom screw
from the main board.
Now screw the enclosed 12 mm spacer (5) into the vacated main board slot.
Mount the enclosed plastic support (6) onto the switch board bottom side.
Put the switch board (4) in the main board connector making sure that the screw
hole is directly above the spacer.
According to your model
If you are mounting the switch into a two-nameplate model, fit the switch
board with the enclosed 10.5 mm spacer (3) and reinstall the button PCB
(1).
If you are mounting the switch into a keypad model, reinstall the beam (8)
of the keypad holder (the slot is on top). Insert the enclosed 4.5 mm
washer (9) between the beam and the switch board, fitting the assembly
with the 15 mm screw enclosed (7).
If you are mounting the switch into a model other than the two ones
mentioned in items 7a and 7b, fit the switch board with the original 6 mm
screw (2).
If you want to use the tamper switch, insert the tamper board (9) in the
connector located in the right-hand bottom part of the switch board (4). As the
tamper switch shares the relay output (NO and NC) terminals, you cannot use
the RELAY2 output with the tamper switch together.
Place front panel back and tighten all four screws.