Static ip address setting for 4-button models, Dynamic ip address setting for 4-button models – 2N Helios IP Force User Manual
Page 50
50
Static IP Address Setting for 4-button models
Follow the instructions below to enable the static IP address mode:
Connect
to the power supply (or, disconnect and
2N
®
Helios IP Force
reconnect it if already connected).
Wait for the first acoustic signal
.
Press buttons 1, 1, 1, 2, 2, 3 sequentially.
The acoustic signal
indicates mode switching.
Wait until the device is restarted automatically.
The device will have the following network parameters after restart:
IP address – 192.168.1.100
Network mask – 255.255.255.0
Default gateway – 192.168.1.1
Dynamic IP Address Setting for 4-button models
Follow the instructions below to enable automatic getting of network parameters from
the DHCP server:
Connect
to the power supply (or, disconnect and
2N
®
Helios IP Force
reconnect it if already connected).
Wait for the first acoustic signal
Press buttons 2, 1, 1, 2, 2, 3 sequentially.
Caution
The 1, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the
first sound signal for security reasons. The inter-digit delay may be 2 s at
most.