Mode switching with 1 or 2-button models – 2N Helios IP Force User Manual
Page 51
51
The acoustic signal
indicates mode switching.
Wait until the device is restarted automatically.
2N
®
Helios IP Force gets the IP address upon restart only if the DHCP server is
configured properly.
Mode Switching with 1 or 2-Button Models
In case your
device is equipped with 1 or 2 buttons, you can
2N
®
Helios IP Force
switch the modes using one button only.
Connect
to the power supply (or, disconnect and
2N
®
Helios IP Force
reconnect it if already connected).
Wait for the first acoustic signal
.
Press
button 15 times.
the first quick dial
The acoustic signal
indicates mode switching.
Wait until the device is restarted automatically.
Caution
The 2, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the
first sound signal for security reasons. The inter-digit delay may be 2 s at
most.