2N Helios IP Force - Manual (Page 53)

53
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
3.
4.
3.2 Control
This subsection describes how to control when viewed by an 2N
®
Helios IP Force
external user.
Speed Dial Buttons
Press the speed dial buttons on the basic unit to make quick dialling for the first 1, 2 or
4 positions (depending on the model type) in the telephone directory. Call setup is
signalled by a long intermittent tone or otherwise as configured in the PBX connected.
Repeated pressing of one and the same speed dial button during call setup may initiate
call termination, or call termination plus dialling the next telephone number of the
called subscriber, or may be assigned no function. This behaviour can be set in unit
configuration.
If your model is equipped with a numerical keypad, you can also push the button
anytime to terminate a call if enabled so in the parameter. Hang up with #
Calling to Telephone Directory Positions
The telephone directory can contain up to 1999 2N
®
Helios IP Force
pre-programmed positions. Speed dial can only be used for positions 1 to 4. The
remaining positions can be retrieved via the numerical keypad if the Speed dial using
function is enabled in configuration. digits
Procedure:
Enter the position number using your numerical keypad (05, 15, 200, 1759 e.g. –
two digits at least and four digits at most) and press for confirmation.
You can also push the button anytime to terminate a call if enabled so in the
parameter in the unit configuration. Hang up with #
Calling to Telephone Number
You can dial a telephone number using your numerical keypad from 2N
®
Helios IP
if the parameter is on. Force Enable telephone function
Procedure:
Press the button.
You will hear the continuous tone from the loudspeaker.
Enter the telephone number using the numerical keypad and repress for
confirmation.
You can also push the button anytime to terminate a call if enabled so in the
parameter; refer to the Miscellaneous subsection. Hang up with #