2N Helios IP Vario User Manual
Page 20
20
8.
9.
10.
11.
12.
13.
14.
15.
Connect the cables as described in subsection 2.4, Mounting – Electrical
Installation. Make sure that the cables are not squeezed while installing the
plastic cover. For the correct cable installation.
Remove the protective foil from the display (for display-equipped 2N
®
Helios IP
versions only).
Vario
Make sure that the cables are placed properly inside and that none of them
obstructs a perfect cover closure.
Make sure that the three loudspeaker holder feet fit into the board holes. Keep
the required loudspeaker position to make the seal work properly.
Having mounted the unit on the wall and connected all cables, replace the plastic
cover using cross-recessed screws.
Take out the name plates from the plastic cover. Use a flat-bladed screwdriver,
for example.
Remove the inserts from the name plates.
Warning
Remember to tighten all the four corner screws to fix the
loudspeaker seal after electric installation to avoid water in-leak! A
PH2 cross-head screwdriver is recommended.