Card reader connection – 2N Helios IP Vario User Manual
Page 30
30
Resetting Procedure – Display Model
Figure:
To reset the default values of a display-equipped
, put the switch
2N
®
Helios IP Vario
in the display right-hand bottom corner in position F_RES. This applies to modules with
board versions 535v1 and 535v2 only. For 535v5 versions, use a jumper at connector
X13.
Card Reader Connection
2N
®
Helios IP Vario (Part Nos. 91371…U) can be equipped with an internal
multifunction module including an RFID card reader (Part No. 9137430E). This module
enhances the
functions with an EM41XX RFID card reader, two
2N
®
Helios IP Vario
relays for external load switching, two logical inputs and RS-485 and Wiegand
interfaces. The current
software version, however, supports the
2N
®
Helios IP Vario
card reader and relays only.
Caution
The
odules ending with U (i.e. 91371…U) can only
2N
®
Helios IP Vario
be equipped with the card reader.