Dynamic ip address setting – 2N Helios IP Vario User Manual
Page 51
51
Dynamic IP Address Setting
Follow the instructions below to enable automatic getting of network parameters from
the DHCP server:
Connect
to the power supply (or, disconnect and reconnect
2N
®
Helios IP Vario
it if already connected).
Wait for the first acoustic signal
Press following buttons sequentially:
2, 1, 1, 2, 2, 3 for 3-buttons models
Figure 3.2 Switching to dynamic IP address
5, 4, 4, 5, 5, 6 for 6-buttons modely
The acoustic signal
indicates mode switching.
Wait until the device is restarted automatically.
2N
®
Helios IP Vario gets the IP address upon restart only if the DHCP server is
configured properly.
Note
The 2, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the
first sound signal for security reasons. The inter-digit delay may be 2 s at
most.