2N Helios IP Vario - Manual (Page 49)

49
2N TELEKOMUNIKACE a.s., www.2n.cz
®
6-buttons models: Press the fifth quick dial button on the basic unit five
times.
2N
®
Helios IP Vario will read its IP address.
If the address is 0.0.0.0, it means that the intercom has not obtained the IP
address from the DHCP server.
Static IP Address Setting
Follow the instructions below to enable the static IP address mode:
Connect to the power supply (or, disconnect and reconnect 2N
®
Helios IP Vario
it if already connected).
Wait for the first acoustic signal .
Press following buttons sequentially:
1, 1, 1, 2, 2, 3 for 3-buttons models
Note
Be sure to press the button sequence within thirty seconds after the
sound signal for security reasons. Up to 2 s intervals are allowed between
the presses.