2N Helios IP Vario - Manual (Page 52)

52
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Mode Switching with 1-Button Models
In case your device is equipped with 1 button, you can switch 2N
®
Helios IP Vario
the modes using one button only.
Connect to the power supply (or, disconnect and reconnect 2N
®
Helios IP Vario
it if already connected).
Wait for the first acoustic signal .
Press 15 times. the quick dial button
The acoustic signal indicates mode switching.
Wait until the device is restarted automatically.
Figure 3.3 Switching between static and dynamic IP address
The static IP address mode will be switched into the dynamic IP address mode and vice
versa upon restart.
Note
The 15 times 1 sequence must be entered within 30 seconds after the first
sound signal for security reasons. The inter-digit delay may be 2 s at
most.