AirLive WIAS-3200N v2 - Manual (Page 11)

2 Getting Started with Easy Setup Utility
5 AirLive WIAS-3200N v2 User’s Manual
Reset to factory default
Press and hold the Scan button for more than 10
seconds until SYSTEM LED FLASH to reset the system
to default configurations.
3 Console Attach the RS-232 console cable here, for management use
only.
4 WAN1/WAN2 Attach Ethernet cables here for connecting to the wired local
network. LAN1 maps to Private Zone and requires no user
authentication, LAN2 maps to Public Zone and by default
requires user authentication.
5 LAN (PoE) Attach the wired external network here. This port supports
Power over Ethernet (PoE) for flexible installation.
6 Reset This is hardware reset button. Press once to restart the
system.
7 STB Connector for
Power Apply
For connecting power input via STB, please refer “Appendix
H. Using STB connector for power input” for more detail.
8 Power Socket
(12VDC/1A)
For connecting to external power supply via the power
adapter.
2.3.2 Rear Panel
Connector Description
Antenna Connector Attach antennas here. WIAS-3200N v2 supports 1 RF
interface with 2 SMA connectors.