AirLive WIAS-3200N v2 - Manual (Page 22)

3. Configure Hotspot to Network
AirLive WIAS-3200N v2 User’s Manual
16
3.2.6 MAC Clone
The MAC address is a 12-digit HEX code uniquely assigned to hardware as identification.
Some ISPs require you to register a MAC address in order to access to Internet. If not, you
could use default MAC or clone MAC from a PC.
Keep Default MAC Address: Keep the default MAC address of WAN port on the
system.
Clone MAC Address: If you want to clone the MAC address of the PC, then click the
“Clone MAC Address” button. The system will automatically detect your PC's MAC
address.
* Note: The Clone MAC Address field will display MAC address of the PC connected to
system. Click Save button can make clone MAC effective.
Manual MAC Address: Enter the MAC address registered with your ISP.
Change these settings as described here and click Save button to save your changes.
Click Reboot button to activate your changes
3.3 WAN Traffic
The section is for administrators to configure the control over the entire system’s traffic
though the WAN interface (WAN1 and WAN2 ports). To configure WAN Traffic, please go
to: System > WAN Traffic.
Primary WAN Interface: Select desired primary WAN interface for system.
Traffic Mode: There are three types: None, Load Balance and Backup.