AirLive WIAS-3200N v2 - Manual (Page 117)

8 View System Log & Status
111 AirLive WIAS-3200N v2 User’s Manual
Route Information: Select “Route Information” on the drop-down list to display route
table.WIAS-3200N v2 could be used as a L2 or L3 device. It doesn’t support dynamic
routing protocols such as RIP or OSPF. Static routes to specific hosts, networks or
default gateway are set up automatically according to the IP configuration of system's
interfaces. When used as a L2 device, it could switch packets and, as L3 device, it’s
capable of being a gateway to route packets inward and outward.
ARP Table Information: Select “ARP Table Information” on the drop-down list to
display ARP table. ARP associates each IP address to a unique hardware address
(MAC) of a device. It is important to have a unique IP address as final destination to
switch packets to.
Bridge Table Information: Select “Bridge Table Information” on the drop-down list
to display bridge table. Bridge table will show Bridge ID and STP's Status on the each
Ethernet bridge and its attached interfaces, the Bridge Port should be attached to
some interfaces (e.g. eth0, eth0.vlan_tag, ath0~ath7).