AirLive WIAS-3200N v2 - Manual (Page 170)

AirLive WIAS-3200N v2 User’s Manual
164
H
16. Appendix H. Using STB
connector for power input
For any DC power input, you may use STB as power convertor.
Step 1. Loosen the screw on top of the STB-male connector
Step 2. Plug in the ground pin of your DC power into the right position hole of STB-male
connector (Shown as Fig1.)
Step 3. Plug in the DC power into the left position hole of STB-male connector (Shown as
Fig1.)
Step 4. Tighten up the screw on top of the STB-male connector, makes sure the DC cable
has been fixed properly.
Step 5. Insert the STB-female connector to the rear side of device (Shown as Fig2.)
*Note: Check the DC power apply to STB connector fist, makes sure the DC power is
12VDC
Fig1. Fig2.