AirLive WIAS-3200N v2 - Manual (Page 24)

3. Configure Hotspot to Network
AirLive WIAS-3200N v2 User’s Manual
18
Service: By default, it's “Disable”. To “Enable” to activate this function.
IP Address To Ping : specify an IP address of the target host which will be monitored
Ping Interval: specify time interval (in seconds) between the ICMP “echo requests”
are sent. (The range is 60-3600, default is 60 seconds.)
Startup Delay: specify initial time delays (in seconds) until first ICMP “echo requests”
are sent. The value of Startup Delay should be at least 60 seconds as the network
interface and wireless connection initialization takes considerable amount of time if the
device is rebooted. (The range is 60-3600, default is 60 seconds.)
Failure Count: specify the number of ICMP “echo response” replies. If the specified
number of ICMP “echo response” packets is not received continuously, the primary
WAN traffic will be routed secondary WAN. (The range is 1-99, default is 1.)
* Note: If Connection Detect is disabled on “Load Balance” or “Backup”, the system will
use default value.
* Note: if “Connection Detection” is disabled and the PHY's connection status shows Red
(Status > Port Link Info). The system will detect PHY on every 5 seconds. When system
detects failure 1 times, the traffic of package will routed via Secondary WAN Interface.
When Primary WAN Interface detects 1 time success, the traffic of package will routed via
Primary WAN Interface.
If “Connection Detection” is disabled and the PHY's connection is Green (Status > Port
Link Info), the system will detect remote Gateway IP address of Primary WAN on every 5
seconds. When system detects failure 3 times, the traffic of package will routed via
Secondary WAN Interface. When Primary WAN Interface detects 1 time success, the
traffic of package will routed via Primary WAN Interface.
Change these settings as described here and click Save button to save your changes.
Click Reboot button to activate your changes
Here is the instruction for how to setup the local LAN/VLAN IP Address and Netmask.
Please click on System > LAN/VLAN, the LAN/VLAN List should be appear. This page
shows information of LAN's/VLAN's settings.