AirLive WIAS-3200N v2 - Manual (Page 13)

2 Getting Started with Easy Setup Utility
7 AirLive WIAS-3200N v2 User’s Manual
2.4 System Requirement
Standard 10/100BaseT including network cables with RJ-45 connectors
All PCs need to install the TCP/IP network protocol
2.5 Installation Steps
Please follow the steps below to install WIAS-3200N v2:
Please follow the steps mentioned below to install the hardware of WIAS-3200N v2:
Step 1. Place the WIAS-3200N v2 at a best location.
The best location for WIAS-3200N v2 is usually at the center of your wireless network.
Step 2. Connect WIAS-3200N v2 to your outbound network device.
Connect one end of the Ethernet cable to the WAN port of WIAS-3200N v2 on the front
panel. Depending on the type of internet service provided by your ISP, connect the other
end of the cable to the ATU-Router of an ADSL, a cable modem, a switch or a hub. The
WAN LED indicator should be ON to indicate a proper connection.
Step 3. Connect WIAS-3200N v2 to your network device.
Connect one end of the Ethernet cable to the LAN port of WIAS-3200N v2 on the front
panel. Connect the other end of the cable to a PC for configuring the system. The LAN LED
indicator should be ON to indicate a proper connection.
1. There are two ways to supply power over to WIAS-3200N v2.
(a) Connect the DC power adapter to the WIAS-3200N v2 power socket on the front
panel.
(b) WIAS-3200N v2 is capable of transmitting DC current via its WAN PoE port.
Connect an IEEE 802.3af-compliant PSE device, e.g. a PoE-switch, to the WAN
port of WIAS-3200N v2 with the Ethernet cable.
2. Now, the hardware installation is completed.
*Caution!! Please only use the power adapter supplied with the WIAS-3200N v2 package.
Using a different power adapter may damage this system.