AirLive WIAS-3200N v2 - Manual (Page 87)

5 Configure Wireless Connection
81 AirLive WIAS-3200N v2 User’s Manual
Tx Power: You can adjust the output power of the system to get the appropriate
coverage for your wireless network. Select LEVEL 1 to LEVEL 7 needed for your
environment. If you are not sure of which setting to choose, then keep the default
setting, LEVEL 7.
When Band Mode select in 802.11b/g/n or 802.11n, the HT Physical Mode settings
should be show immediately.
Tx/Rx Stream: By default, it's 2.
Channel Bandwidth: The "20/40” MHz option is usually best. The other option is
available for special circumstances.
Extension Channel: Only for Channel Bandwidth “40” MHz Select the desired
channel bonding for control.