AirLive WIAS-3200N v2 - Manual (Page 38)

3. Configure Hotspot to Network
AirLive WIAS-3200N v2 User’s Manual
32
3.8 SNMP
SNMP is an application-layer protocol that provides a message of format for
communication between SNMP managers and agents. By enabling SNMP function, the
administrator can obtain the system information remotely. Please click on System > SNMP
Setup and follow the below setting.
3.8.1 SNMP v2c
Enable: Check to enable SNMP v2c.
ro community : Set a community string to authorize read-only access.
rw community : Set a community string to authorize read/write access.
3.8.2 SNMP v3
Enable: Check to enable SNMP v3. SNMPv3 supports the highest level SNMP
security.
SNMP ro user: Set a community string to authorize read-only access.
SNMP ro password: Set a password to authorize read-only access.
SNMP rw user: Set a community string to authorize read/write access.
SNMP rw password: Set a password to authorize read/write access.
3.8.3 SNMP Trap
Events such as cold start, interface up & down, and association & disassociation will report
to an assigned server.
Enable: Check to enable SNMP Trap.
Community: Set a community string required by the remote host computer that will
receive trap messages or notices sends by the system.
IP: Enter the IP addresses of the remote hosts to receive trap messages.
Change these settings as described here and click Save button to save your changes.
Click Reboot button to activate your changes