C.B.S. Scientific TTGEK-2401-220 - Manual (Page 46)

46
www.cbsscientific.com
3.10 Removing the Gels
1. When run is completed, turn off power supply, disconnect recirculating tubes and power
leads, remove cassettes from tank and unclamp glass sandwiches from cassettes.
Remove Gel Wrap™ by pulling away from plate.
2. Using a wedge plate separator,cat. # WPS-100, pry plates apart and immerse gel/plate
in buffer tray. Stain with EtBr (0.5g/ml) for 5-10 minutes. Lift gel on plate out of tray and
rinse with ddH20. Flip over onto Saran® wrap and peal off glass plate. View bands on
transilluminator. Electro-Blot or photograph.
3. If using borosilicate glass plates, scan EtBr stained bands directly through glass without
disassembly of gel plate sandwich.