Comelit MT CT 01 - Manual (Page 30)

MT CT 01
MT CT 01 29
5 SWITCHBOARD SERVICES
I
NTRODUCTION
:
All the services described in this chapter, except for 5.1, consist of an initial configuration stage and a
second enabling stage. It is not possible to enable a service which is not configured. The operations which
can only by carried out by the telephones configured as Operator Post are marked with the acronym OP.
5.1 D
AY
/
NIGHT SERVICE
5.1.1 Description
Two switchboard operating methods are possible defined as DAY scenario or NIGHT scenario, which differ in:
Different configuration of the outside lines on input or output per individual the branch.
Different distribution of the entry phone calls over the branched telephones.
Different characterisation of the extension branches.
Different activation of the COURTESY MESSAGE –FAX RECOGNITION – DISA services etc.
Passing from one scenario to the other takes place manually by keying in a command, or automatically at times
established by the user.
5.1.2 Activation (OP)
It is possible to activate the DAY or NIGHT scenario by keying in the following codes:
5.2 A
UTOMATIC DAY
/
NIGHT SERVICE
5.2.1 Description
This allows passing from the DAY scenario to the NIGHT one at established times.
When the service is de-activated, the switchboard goes onto DAY.
5.2.2 Configuration
Enter the configuration state (See paragraph 8.0).
DESCRIPTION COMMAND PARAMETER VALUES
7 * 2 #
7 * 1 # Activation of the DAY scenario
Activation of the NIGHT scenario
DESCRIPTION COMMAND PARAMETER VALUES
Setting the DAY/NIGHT
changeover time
Setting the NIGHT/DAY
changeover time
7 5 a b c d e #
7 6 a b c d e #
a = 1 (partition 1)
2 (partition 2)
b c = hours
d e = minutes
a = 1 (partition 1)
2 (partition 2)
b c = hours
d e = minutes
a = 1 (partiz. 1)
2 (partiz. 2)
b c = ore
d e = minuti
DEFAULT VALUES: 20:30 - 8.30
EXAMPLE: 75 1 20 30 #
partition 1 is in the day scenario from 08:30 to 20:29,
75 1 08 30 # in the night scenario from 20:30 to 08:29.
DEFAULT VALUES: The DAY scenario is activated.