Mt ct 01 – Comelit MT CT 01 User Manual
Page 32
MT CT 01
MT CT 01
31
5.3.3 Activation / Deactivation (OP)
(*) Recording of the message starts after having pressed button “a” ( Day/Night ) and ends when “#” is
pressed or the receiver is put down.
5.4 A
UTOMATIC FAX RECOGNITION
5.4.1 Description
By activating this service it is possible to recognise fax calls automatically. In detail, on receipt of a telephone
call the switchboard replies engaging the line, it waits for 4 seconds during which it verifies whether the remote
caller is a fax, and if this is so, diverts the call to the fax or tel-fax branch, if not, it sends the call according to
the methods programmed. The music on hold is sent to the remote user, and the line will be released if no user
replies within 60 seconds.
To inform the caller better that his call has been sent , it is advisable to combine this service with the
COURTESY MESSAGE one. In this case, instead of the music on hold, a message of the type “This is the
company Asse, please hold the line, an operator will be at your disposal” will be sent.
5.4.2 Configuration
Enter the state of configuration (See paragraph 8.0).
Refer to the configuration described in paragraph 8.6 to characterise the fax or tel-fax branch based on the
characteristics of the fax to be connected.
The switchboard sends a fax type call only to a branch programmed as such.
5.4.3 Activation / Deactivation (OP)
a = 0 (Day)
1 (Night)
# = end of recording
a = 0 (Day)
1 (Night)
DESCRIPTION
COMMAND
PARAMETER VALUES
Deactivation
Activation
Recording of message (*)
Listening to the message
7
0
0
7
0
1
7
0
2
a
7
0
3
a
DESCRIPTION
COMMAND
PARAMETER VALUES
7
1
1
7
1
0
Deactivation
Activation