Comelit MT CT 01 - Manual (Page 36)

MT CT 01
MT CT 01 35
5.8.2 Configuration
Enter the state of configuration (See paragraph 8.0).
5.8.3 Activation / Deactivation (OP)
5.9 R
EMOTE SOS LINE
5.9.1 Description
With expansion card 2913 it is possible to use the remote SOS line function.
If the service is enabled, on pressing the remote control ( Art.1914 ) button the switchboard operates in one of
the following 3 ways.
1. “signalling” : Branches ring for 4 seconds and the service ends.
2. “SOS” : This consists of the following stages:
a. the branches ring for 4 seconds.
b. the switchboard engages the outside line and calls the first number on the list. At this point:
• When the remote user replies the recorded message is sent on line, for the number of times
programmed ( from 5 to 9 ). The branches ring for 2 seconds; by lifting the receiver from one of these,
you go into communication with the remote user and the service will be ended.
• Once the previous stage has ended, the switchboard dials the next number.
• When all the numbers programmed in the list have been called, the cycle is repeated for the number of
times programmed by the user (from 5 to 9).
The remote user who replied can exclude himself from the list by pressing DTMF digit 9.
3. “alarm” : this is the same as the “SOS” method, except that the branches do not ring when the service is
activated and when the message is sent on line.
a = 1-2 (line )
a = 1-2 (line )
DESCRIPTION COMMAND PARAMETER VALUES
7 5 0 a
7 5 1 a
Deactivation
Activation
a = 1-2 (incoming outside line)
b = 0 (resets configuration)
1-2 (outgoing outside line)
3 (first available)
c = 0 (Day)
1 (Night)
d = telephone number
(max 16 digits)
DESCRIPTION COMMAND PARAMETER VALUES
Configuration
DEFAULT VALUES: Service not configured.
EXAMPLE: 33 1 2 0 034675001# Call from outside line 1 diverted to outside line 2 on number 0346750001
in the DAY scenario
33 2 1 1 034675002# Call from outside line 2 diverted to outside line 1 on number 0346750002
in the NIGHT scenario
3 3 a b c d … #