Comelit MT CT 01 - Manual (Page 42)

MT CT 01
MT CT 01 41
5.10.4 Activation of Filters on a branch
It is possible to set two different types of filters on each branch:
• Blocks enabled: the rules set in Configuration of Filters for each outgoing telephone call are valid.
• Directory: it is only possible to call the numbers stored in the directory, which will not be subject to filters.
6 AUXILIARY TELEPHONE SERVICES
The operations which can only by carried out by the telephones configured as Operator Post are
marked with the acronym OP.
6.1 R
ELEASING OUTGOING CALLS
It is possible to temporarily disable a possible filter on outgoing calls.
This takes place in the following way:
• The branch digit 6* followed by the “Password for releasing filters”.
• The branch hangs up.
• The branch lifts the receiver and makes a call on the outside line.
• The call will not be subject to filters.
6.2 R
EPLY FOR ABSENT
A branch can answer a call addressed to another extension. This takes place with the following method:
• Branch 802 calls branch 803.
• Branch 803 rings.
• Branch 801 dials 6103 and goes into communication with the caller (802).
6.3 B
OOKING EXTENSION
/
OUTSIDE LINE
A branch can book an extension / outside line found to be engaged.
This takes place with the following method:
• Branch 801 calls branch 803.
• Branch 803 is engaged.
• Branch 801 dials 8 on the engaged tone receiving the confirmation tone.
• Branch 801 hangs up.
• Branch 803 hangs up.
• Branch 801 rings and when the receiver is lifted it will make branch 803 ring.
ab = Number of branch ( 01 - 08 )
c = Type of block:
0 (None)
1 (Blocks enabled)
2 (Directory)
DESCRIPTION COMMAND PARAMETER VALUES
Activation of filter on branch
abcd = password of 4 digits ( default = 0000 )
COMMAND PARAMETER VALUES
6 *
a b = number of branch ( 01-08 )
PARAMETER VALUES
6 1
COMMAND
a b
a b c d
DEFAULT VALUES: All the branches with no filter active.
2 8 a b c #