Comelit MT CT 01 - Manual (Page 34)

MT CT 01
MT CT 01 33
5.6.2 Configuration
Enter the state of configuration (See paragraph 8.0).
5.6.3 Activation / Deactivation (OP)
5.7 E
NTRY PHONE FOLLOW
-
ME
5.7.1 Description
If the entry phone expansion card 2909 is present, it is possible to activate the Follow-me service which allows an
entry phone call to be diverted to a telephone number programmed by the user. When the remote user receives the
call and replies, they will be put in communication with the external unit entry phone and the following will be possible:
a. control the relay on card art.2909 ( see par. 7.2 )
b. end the conversation by pressing DTMF digit 0
c. the conversation is timed at 1 minute. It is possible to renew it by pressing any DTMF digit when the switch-
board signals with a tone the time is running out. It is not possible to carry out the entry phone Follow-me ser-
vice if the outside line on which the service is configured is engaged in other conversations.
In this case a simple entry phone call will be sent.
DESCRIPTION COMMAND PARAMETER VALUES
6 9
7 0
a = 1 ( relay N1 – C1 )
2 ( relay N2 – C2 )
3 ( relay N3 – C3 )
b = 0 (Monostable) 1 (Bistable)
cd = 01 : 99 (Duration in seconds
if monostable )
e = 0 (Relay N2 – C2 for general uses)
1 (Relay N2 – C2 for internal
Turning on use)
a = 4 digits (Password)
b = 4 digits (password repetition)
Configuration
of relay
Definition of
Password
a = 0 (Day)
1 (Night)
b = 1-2 (List of Lines)
Enabling Lines
a = 0 (Day)
1 (Night)
b = 1-2 (List of Lines)
Disabling Lines
DESCRIPTION COMMAND PARAMETER VALUES
7 3 1
7 3 0 Deactivation
Activation
a
a
b c d e #
b #
DEFAULT VALUES: All the relays configured as monostable with a closing time of 1 second.
Relay N2 – C2 is configured for internal Turning on use. Password = 0000.
Service not configured on all the lines either in DAY or NIGHT scenario.
7 1 a b #
7 2 a b #