Comelit MT CT 01 - Manual (Page 53)

GROUP S.P.A.
MT CT 01 52
8.10 G
ROUPS OF BRANCHES
8.11 CLI (CALLER ID)
This service is only possible on the outside line of the telephone operator (TELECOMITALIA for Italy) if:
1) the user has signed a subscription with the operator;
2) a telephone preset for this function is used;
If these conditions are fulfilled, the service allows the number of the caller to be shown on the display both
during the call stage (CLI ON-HOOK i.e. with "receiver put down) and, should the user be subscribed to the
"call waiting" service, also during conversation (CLI OFF-HOOK i.e. with "receiver lifted").
In "Caller ID" during the call stage, between the first and second ring, the telephone operator sends the caller
number. If the user replies before the second ring, the number will not be displayed.
In " Caller ID" during the conversation stage you will notice a short break in the communication.
8.12 I
NCOMING CALL OPERATION
DEFAULT VALUES: No group configured.
EXAMPLE: 27 1 010203 # to define group 1 consisting of branches: 01 – 02 – 03
27 2 010405# to define group 2 consisting of branches: 01 – 04 – 05.
A branch is allowed to belong to several groups.
a = 1-5 (Number of the group).
0 (to cancel all the groups, the next parameter
is not needed).
bc = 01-08 (List of branches belonging to the same
partition; 2 digits as tens and units).
00 (To cancel the group specified by
parameter a).
COMMAND PARAMETER VALUES
2 7 a b
ab = 01÷08 (Branch)
c =
CLI ON-HOOK
1 (Activated)
0 (Not activated)
d = CLI OFF-HOOK
1 (Attiva)
0 (Not activated)
COMMAND PARAMETER VALUES
2 9 a b c d #
a = 1 (Partition 1)
2 (Partition 2)
b = 0 (All branches)
1 (Operator Post)
COMMAND PARAMETER VALUES
3 0 a b
DEFAULT VALUES: All branches with CLI ON-HOOK activated.
All branches with CLI OFF-HOOK deactivated.
DEFAULT VALUES: Incoming calls addressed to Operator Post.
#
c … #