INFICON Ecotec E3000 Multigas-Sniffer-Leak Detector - Manual (Page 28)

28
6 Operation
Tr
an
sl
ation
o
f the
o
rig
in
al
operatin
g
in
str
u
ct
io
ns
Ecot
ec E3
000,
k
in
a
22en
1
-r
, 1
407
6.3 Settings before measurements
Before the first measurements, you should make different device settings in the following
menus:
 Miscellaneous
 Display
 Audio
 Vacuum & access control
 Interfaces (for control via interfaces and if you use an ECO-Check)
You can access the menus via the main menu
6.3.1 Miscellaneous
Language You can select one of the following languages:
 English (factory setting)
 German
 French
 Italian
 Portuguese
 Spanish
 Japanese (Katakana)
 Chinese (Mandarin, simplified Chinese)
To set the language to English temporarily, press keys two and six during the run-up of the
Ecotec. Call up the language setting after the run-up and set the required language.
Time & Date
 First page: internal date with the format DD.MM.YYYY
 Second page (press key on the bottom right ) time with the format SS:MM.
Sniffer light
 Activate/deactivate light
 Adjust brightness from 1 (min) to 6 (max)
Pressure unit
 atm
 Torr
 Pa
 mbar
Leak rate filter
 Auto
 Fixed
 I•Filter
The I•Filter is an intelligent filter algorithm that delivers the best results regarding
interference suppression and stability of the leak rate signal. It was especially developed
for the use in the Ecotec E3000.
Only in cases in which the older Ecotec II model was replaced with an Ecotec E3000 and
the Ecotec E3000 is used in a fixed test device can it be necessary to select the older filter
settings “Auto” or “Fixed”.