INFICON Ecotec E3000 Multigas-Sniffer-Leak Detector - Manual (Page 66)

66
8 Maintenance
Tr
an
sl
ation
o
f the
o
rig
in
al
operatin
g
in
str
u
ct
io
ns
Ecot
ec E3
000,
k
in
a
22en
1
-r
, 1
407
Warning reminder
If the maintenance plan is activated but no maintenance work is confirmed, the warning
“Reminder of pending maintenance work” will be displayed every two hours. You can
deactivate the repeated display of this warning in “Warning reminder”.
Select filament
(cathode) In this window, you can switch from cathode B back to cathode A if the device has
independently selected cathode B. The setting can only be made in the idle state and with
a stopped turbo molecular pump.
Select the cathode and confirm with “OK”.
Replacing ECO-Check If an ECO-Check calibrated leak is connected or the gas store of the ECO-Check us
replaced, you have to enter the serial number as well as the identification with the
calibration data. The installation of the ECO-Check in the Ecotec E3000 as well as the gas
store replacement are described in the ECO-Check manual.
The ECO-Check must be connected to the device. You must write down the serial number
and the identification on the gas store or you can refer to the supplied certificate for that
information.
The appropriate entry window opens with “Replacing the ECO-Check”.
Fig. 45: Enter serial number and identification of the gas store.
The Ecotec E3000 checks the entered number. It will report “Invalid entry” if the ECO-
Check cannot be identified with the number.
8.2 Maintenance work
Failure to perform the maintenance work specified in the maintenance schedule will void
the warranty.
Danger to life due to electric shock
Inside the device there are voltages of considerable magnitude. Touching parts where
electric voltage is applied can result in death.
► Disconnect the device from the power supply prior to any maintenance work. Make
sure that the electric power supply cannot be reconnected unauthorized.