INFICON PSG55x ATM to Medium Vacuum Gauge (Profibus) - Manual (Page 24)

24
tira56e1 (2010-02) PxG55x.cp
The Block Type ID Parameter contains an ID which describes the block type. The
block type ID of the "Device Block" is set to "1". The other defined block types are
listed in Appendix B.
The Device Type parameter identifies the device type which is connected to the
field bus via Profibus.
The Device Type of the PSG55x gauge is "VPG" which is an acronym for "Vacuum
Pressure Gauge".
The Device Type of the PCG55x gauge is "CVG" which is an acronym for
"Combination Vacuum Gauge".
This parameter describes the version of the "Sensor/Actuator Network Specific
Device Model" published by the SEMI
® (Semiconductor Equipment and Materials
International, California), according to which the profile of this device has been
developed.
The fixed setting of this parameter is "E54-0997".
This parameter describes the manufacturer of the device. It is set to
"INFICON AG".
This parameter provides the part number of the gauge. →  3 "Validity"
This describes the version of the Profibus firmware in the following format: xxyyzz
(where 'xx' is the compatibility index, 'yy' is the actual version, 'zz' is the developing
version).
This parameter describes the version of the Profibus adapter hardware in the
following format: xxyyzz (where 'xx' is the generic version, 'yy' is the actual version,
'zz' is the developing version).
This parameter provides the serial number of the device.
7.1 Information on the
individual Indices
7.1.1 Block Type ID (ID 16)
7.1.2 Device Type (ID 17)
7.1.3 Standard Revision Level
(ID 18)
7.1.4 Device Manufacturer
Identifier (ID 19)
7.1.5 Manufacturer Model
Number (ID 20)
7.1.6 Software or Firmware
Revision Level (ID 21)
7.1.7 Hardware Revision Level
(ID 22)
7.1.8 Serial Number (ID 23)