JUMO PCA Communications Software PCC (B 70.9702.0) - Manual (Page 52)

7 Archive
52
Archives for
automatically read data
Archives for manually
read data
Current default archive (directory)
v Chapter 8.1.5 "Default Settings"
Active ( ):
Accepts each data block individually for evaluation, directly after reading
out.
Inactive (
):
All the data in the archive that is not yet in evaluation (e.g. previously read
data, or data from a CF card) will not be evaluated until the end of reading
out.
Active ( ):
Data is immediately accepted for evaluation.
In PCA3000, this means that the archives will be opened faster.
Click (with the left
mouse button) to
start the
PCA3000
software and
bring up the
archive data in
the display.
If there are
several archive
files in the
directory for a
device, then the
first archive that
is found will be
used.
Archives for manually
read data
Using an output form
v Page 54
Changing archive automatically
v Page 54
A
Archive directory:
Data is saved in all archive files with the same device identifier (Manf. No.,
CPU No., or config checksum; depends on device type). If there is no
archive, a new one will be created.
File name = device identifier
Archive file:
Data will only be stored in this archive. The archive must have the same
device identifier as the device itself. If the archive does not match the device
and no matching password is found, a new one is created.
If, for instance, it is not possible to store data on a network, it will be stored
in the default archive.