JUMO PCA Communications Software PCC (B 70.9702.0) - Manual (Page 66)

8 Menu Functions and Toolbar
66
8.3 Data Transfer
8.3.1 Reading out Raw Data (Manually)
Depending on the device that is used, different information must be provided
when manually reading out raw data.
LOGOSCREEN
500cf/es/cf/nt For devices of type LOGOSCREEN 500 cf, LOGOSCREEN es,
LOGOSCREEN cf and LOGOSCREEN nt (device type 2) you can set what data
is required by the device.
First, the software establishes a connection to the device.
You can close the dialog (or move it) and carry on working through the PCC
software. When the connection has been established, the data selection
follows. Every change to the configuration requires a new entry to be made in
the list.
For example if the configuration of a measurement input is changed, then a
new entry has to be made, because different measuring ranges require
different scalings in PCA3000.
h Select the required entry from the list and set the time limits if necessary.
H
The value for the memory alarm is not affected, i.e. the data will be
read out, but not marked as “retrieved”!