Lenze E94APNExxx4 - Manual (Page 42)

Technical data
General data and operating conditions
3
l
42 EDK94PNE245 DE/EN/FR/ES/IT 2.0
3 Technical data
3.1 General data and operating conditions
Conformity and approval
Conformity
CE 2006/95/EC Low−Voltage Directive
Approval
In preparation: UL UL 508C Industrial Control Equipment, file no. 132659
Supply system data
Supply forms With earthed
*
point
Unrestricted use
IT systems Unrestricted use
Observe instructions about special measures concerning the
connected axis controllers!
Noise emission EN 61800−3 Conducted: cannot be specified because dependent on the
conditions present in the interconnected system
Radiation: category C3
Noise immunity (according to requirements of EN 61800−3)
Electrostatic discharge
(ESD) EN 61000−4−2 8 kV for air discharge,
4 kV for contact discharge to housing
Radio frequency
Conducted EN 61000−4−6 150 kHz ... 80 MHz, 10 V/m 80 % AM (1 kHz)
Radiation (housing) EN 61000−4−3 80 MHz ... 1000 MHz, 10 V/m 80 % AM (1 kHz)
Protection of persons and equipment
Enclosure EN 60529 IP 20
Not in the wiring area of
the lower terminals
NEMA 250 Protection against contact to
type 1
Insulation resistance EN 61800−5−1 Overvoltage category III
Derating at and above 2000 m amsl: overvoltage category II
Insulation of control
circuits EN 61800−5−1 Safe mains isolation by double/reinforced insulation.
Short−circuit strength EN 61800−5−1 DC−bus connection: not short−circuit−proof
Brake resistor connection: fully short−circuit proof
Control connections: fully short−circuit proof
Leakage current EN 61800−5−1 > 3.5 mA Observe regulations and
safety instructions!
Cyclic mains switching Cyclic mains switching of 5 times within 5 minutes is
permitted without restrictions.
Mounting conditions
Mounting place In the control cabinet
Mounting position Vertical
Mounting clearances
Above/below ³ 80 mm / ³ 120 mm
Observe the device−related
notes on mounting.
To the sides Side−by−side mounting without
any clearance