Lenze S94P01B2 - Manual (Page 19)

S94P01B2
17
Interface
Pin Name Function
10 BB- Buffered Encoder Output: Channel B- (1)
11 BZ+ Buffered Encoder Output: Channel Z+ (1)
12 BZ- Buffered Encoder Output: Channel Z- (1)
13-19 Empty
20 AIN2+ Positive (+) of Analog signal input
21 AIN2- Negative (-) of Analog signal input
22 ACOM Analog common
23 AO Analog output
24 AIN1+ Positive (+) of Analog signal input
25 AIN1 - Negative (-) of Analog signal input
26 IN_A_COM Digital input group ACOM terminal (3)
27 IN_A1 Digital input A1
28 IN_A2 Digital input A2
29 IN_A3 Digital input A3 (3)
30 IN_A4 Digital input A4
31 IN_B_COM Digital input group BCOM terminal
32 IN_B1 Digital input B1
33 IN_B2 Digital input B2
34 IN_B3 Digital input B3
35 IN_B4 Digital input B4
36 IN_C_COM Digital input group CCOM terminal
37 IN_C1 Digital input C1
38 IN_C2 Digital input C2
39 IN_C3 Digital input C3
40 IN_C4 Digital input C4
41 RDY+ Ready output Collector
42 RDY- Ready output Emitter
43 OUT1-C Programmable output #1 Collector
44 OUT1-E Programmable output #1 Emitter
45 OUT2-C Programmable output #2 Collector
46 OUT2-E Programmable output #2 Emitter
47 OUT3-C Programmable output #3 Collector
48 OUT3-E Programmable output #3 Emitter
49 OUT4-C Programmable output #4 Collector
50 OUT4-E Programmable output #4 Emitter
(1)
See Note 1, Section 4.1.7 - Connector and Wiring Notes
(2)
See Note 2, Section 4.1.7 - Connector and Wiring Notes
3)
See Note 3, Section 4.1.7 - Connector and Wiring Notes
4.1.4 P4 - Motor Feedback / Second Loop Encoder Input
P4 is a 15-pin DB connector that contains connections for Hall Effect sensors and
incremental encoder feedback. Refer to the P4 pin assignments table for the connector
pin assignments. Encoder inputs on P4 have 26LS32 or compatible differential receivers
for increased noise immunity. Inputs have all necessary filtering and line balancing
components so no external noise suppression networks are needed.
All conductors must be enclosed in one shield and jacket around them. Lenze
recommends that each and every pair (for example, EA+ and EA-) be twisted. In order
to satisfy CE requirements, use of an OEM cable is recommended. Contact your Lenze
representative for assistance.