Lenze ECSDKxxx - Manual (Page 46)

Technical data
Rated data
2
l
46 EDKCSDK002 DE/EN/FR 1.1
General electrical data
EMC Compliance with EN 61800−3
Noise emission Compliance with limit value class A to EN 55011
(achieved with application−specific collective filter)
Noise immunity Requirements to EN 61800−3
Requirements Standard Severity
ESD 1) EN 61000−4−2 3, i. e.
l 8 kV with air discharge
l 6 kV with contact
discharge
High frequency in cables EN 61000−4−6 10 V; 0.15 ... 80 MHz
RF interference
(enclosure) EN 61000−4−3 3, i. e. 10 V/m;
80 ... 1000 MHz
Burst EN 61000−4−4 3/4, i. e. 2 kV/5 kHz
Surge (on mains cable) EN 61000−4−5 3, i. e. 1.2/50 ms
l 1 kV phase−phase
l 2 kV phase PE
Insulation resistance Overvoltage category III to VDE 0110
Discharge current against PE (to EN 50178) > 3.5 mA AC for operation with corresponding controllers
Enclosure l IP20 for standard mounting
l IP20 for mounting in cold−plate technique
l IP20 for mounting in push−through technique; IP54 on the heatsink
side
Protective insulation of control circuits Safe disconnection from supply: Double/reinforced insulation to
EN 50178;
Rated insulation voltage 300 V x
√2
1) Noise immunity in the above−mentioned severities must be guaranteed through the
control cabinet! The user must check the compliance with the severities!
2.2 Rated data
,
The most important rated data are located on the nameplate of the
device. Additional data can be found in the detailed documentation.