MK Diamond MK-660 User Manual
Page 17
17
(A)
Place the Flat Washer onto
the Height Adjusting Knob
MK-660 tile saw
asseMBlY
CUttiNG HeaD iNstallatiON
Follow the assembly instructions to prepare your MK-660 Saw for operation.
NOte:
If the Cutting Head is installed, go to step next step.
(B)
Align Cutting Head Pivot
Hole to the Post, Pivot Shaft
(C)
Verify the Cutting Head is
completely installed and seated
on the Pivot Shaft
(D)
Install the Adjusting Knob
DiaMOND BlaDe iNstallatiON
NOte:
When installing the Retaining Screw, do not “cross-thread" and DO NOT over tighten the
screw.
(A)
Loosen the Blade Guard
Retaining Screw
(B)
Open the Outer Blade Guard to
expose the Retaining Nut and
Flanges
(C)
Using the Blade Nut Wrench,
loosen and then remove the
Retaining Nut and Outer Flange