MK Diamond MK-660 - Manual (Page 28)

28
MK-660 tile saw CleaNUP
(G)
Clean the MK-660 Saw with
soap and clean water
(H)
Remove the Water Pan from
the MK-660 Saw
(I)
Clean the Water Pan
(J)
Clean the movable Cutting
Table Guide Bar
(K)
Clean the movable Cutting
Table Roller Wheel Frame
Support
(L)
Clean the remainder of the
MK-660 Saw
Ensure water is not forced into the motor casing when cleaning. CaUtiON
MaiNteNaNCe FOllOwiNG Use
To extend the life of the MK-660 Saw, the following procedure should be performed after each use.
Lubricate all points listed below with light oils such as, 3 in 1, WD-40, etc.
(A)
Ensure the ON/OFF switch is
in the OFF position
(B)
Unplug MK-660 Saw
(C)
Lubricate the Guide Bar