MK Diamond MK-660 - Manual (Page 33)

33
MK-660 tile saw MaiNteNaNCe
DiaMOND BlaDe CHaNGe-OUt
When installing the Retaining Screw, do not "cross-thread" and DO NOT over tighten the screw. NOte:
(A)
Open the Outer Blade
(B)
Remove Retaining Nut and
Outer Flange
(C)
Remove Diamond Blade
from Blade Shaft
(D)
Install the Diamond Blade
onto Blade Shaft
(E)
Verify the Blade is seated on
the Blade Shaft and direction of
rotation is correct
(F)
Install the Retaining Nut and Outer
Flange. Hold the Blade Shaft
using the Inner Flange Retain-
ing Wrench and tighten using the
Blade Wrench
(G)
Close the Outer Blade Guard
and tighten the Blade Guard
Retaining Screw
(H)
Tighten the Outer Blade Guard
Pivot Screw