MK Diamond MK-660 - Manual (Page 18)

18
MK-660 tile saw asseMBlY
(D)
Locate the Inner Flange
Wrench Retaining Holes
(E)
Install Diamond Blade
onto Blade Shaft
(F)
Verify the Blade is seated on the
Blade Shaft and direction
of rotation is correct
(G)
Install the Retaining Nut and Outer
Flange. Hold the Shaft using the
Inner Flange Retaining Wrench
and tighten using the Blade
Wrench
(H)
Close the Outer Blade Guard
and tighten the Blade Guard
Retaining Screw
(I)
Tighten the Outer Blade Guard
Pivot Screw
aDJUstaBle CUttiNG GUiDe iNstallatiON
(A)
Loosen adjustable Cutting
Guide retaining thumbscrew and
place it over the movable
Cutting Table Ruler/Stop
(B)
Place the adjustable Cutting
Guide onto the movable Cutting
Table Ruler/Stop and tighten the
retaining thumbscrew