MK Diamond MK-660 User Manual
Page 22
22
1. Check for damaged, broken, or missing parts.
2. Verify the On/Off switch is in the OFF position.
3. Before connecting the MK-660 Saw to a power supply, be sure the voltage, cycle
and phase of the job site power source meet the requirements of the table below:
(A) Ensure the ON/OFF Switch is in the OFF position
(B) Plug MK-660 Saw into the GFCI
(C) Plug the GFCI into the power source
VOLTAGE:
120v
CYCLE:
60hz
PHASE:
1-phase
MK-660 tile saw
OPeRatiON
MK-660 saw setUP FOR OPeRatiON
CaUtiON
If using a portable generator to provide power, ensure the generator meets the following minimum
requirements: 8 KW 120/240 volts
66.7/33.3 amps
Single Phase
4. If using an extension power cord, make sure the length and wire gauge
correspond to the requirements listed in the table on page 10. An extension
power cord that is too small in wire gauge (diameter), or too long in length, will
cause the motor to overheat and could cause premature failure.
5. Use an approved Ground Fault Circuit Interrupter (GFCI).
6. Do not cover the motor vents as this could lead to motor overheating.
NOte:
NOte:
PORtaBle GeNeRatOR
In order to avoid breaker tripping, a 20-amp circuit breaker should be used.
MK Diamond has available, as an accessory item, (Part # 152610) a plug-in GFCI that
may be plugged into a properly installed and grounded 3-pole outlet.