MK Diamond MK-660 - Manual (Page 24)

24
MK-660 tile saw OPeRatiON
DiaGONal CUttiNG
NOte: To cut 45º Diagonals, the 45º Flat Angle Guide (MK Diamond Part No. 134577-MK) should be
used.
DO NOt FORCe tHe tOOl. It will do the job better and safer at the rate for
which it was designed.
CaUtiON
(A)
Remove the adjustable Cut-
ting Guide
(B)
Place the Dual 45° Flat Angle
Guide on the Ruler/Stop
(C)
Position the Dual 45° Flat Angle
Guide and tighten the retaining
thumbscrew
NOte: If cutting the tile in two equal halves, align the tile in the V-notch of the movable Cutting Table Ruler/Stop.
(D)
Position the tile against the
Dual 45° Flat Angle Guide
and the Ruler/Stop
(E)
Turn the motor ON
(F)
Verify cooling flow on both sides
of the blade (See Maintenance
Section to adjust flow)
(G)
Perform the cut
(H)
Turn the motor OFF when
work is complete