New Era NE-9000 Series Programmable Peristaltic - Manual (Page 26)

New Era Pump Systems Inc.
www.SyringePump.com
Model NE-9000
Publication #1200-04 18
F) The pump is powered on.
When the Pumping Program is stopped, and the display shows the Program function or pumping rate
information, the accumulated Volume Dispensed can be displayed by pressing the ‘Volume’ key one, two,
or three times, depending on the current display.
7.8 Resuming When Paused
If the Pumping Program is stopped before the completion of the Pumping Program, the ‘Pumping’ LED
will blink, indicating that the Pumping Program is paused. While the ‘Pumping’ LED is blinking, starting
the pump again will resume the Pumping Program where it was stopped. This means that the Pumping
Program will continue at the point in the Phase where it was stopped and the ‘Volume to be Dispensed’
will still be referenced from when the Program Phase first started.
Pressing any key other than the ‘Start’ key will cancel “Pumping Program paused” and the ‘Pumping’
LED will stop blinking. When the Pumping Program is started again, it will start from the beginning
(Phase 1).
8. Learn and Repeat
“Learn and Repeat” easily teaches the pump a dispense volume. Then you can immediately repeat this
dispense. Dispense Mode must be set to repeat a dispense.
While turning on power, press and hold the ‘LEARN’ key. The display will show:
Press and hold the ‘Start’ key to begin dispensing. As the desired volume is approached, you can release
the key to stop the pump, then periodically press the ‘Start’ key to slowly and accurately approach your
dispense volume.
While pumping, the volume dispensed will be displayed. When the ‘Start’ key is released, the display will
alternate between displaying the volume dispensed and the currently selected dispense setting number.
Press the ‘LEARN’ key, or wait for the time out, to immediately store the dispensed volume in the
currently selected dispense setting. A double beep will sound and the display will show:
Press any key to return to the currently selected dispense program display.
Press ‘Start’ to immediately begin the newly learned dispensed.
Storing in a different dispense selection number
The learned dispense can be stored in a different dispense setting number. After the required dispense
volume is reached, press any of the up arrow keys. The display will show:
nn
Where ‘nn’ is the crrently selected dispense setting number. Use the up arrow keys to select a different
location to store the dispense. Press the ‘LEARN’ button or wait for the time out. A double beep will
sound and the display will show:
Press the ‘Start’ key to immediate begin dispensing the learned dispense.