New Era NE-9000 Series Programmable Peristaltic User Manual
Page 55
New Era Pump Systems Inc.
www.SyringePump.com
Model NE-9000
Publication #1200-04
47
Set/Query Program Entry Mode Lockout. Set Program Entry Mode Lockout prevents
inexperienced users from entering “Program Entry Mode” from the keypad. When enabled, only
the Phase 1 ‘Rate’, ‘Volume’ and Pumping Direction can be changed. Cannot be enabled when
the Pumping Program is currently programmed with a multiple Phase Program.
D [ <on-off> ]
Set/Query Dispense Mode. Set Dispense Mode allows quick setup and selection of dispenses.
Turn off to enter a Pumping Program.
SET KEY BEEP
BP [ <on-off> ]
Set/query key beep mode. Set key beep enables or disables key beep mode.
12.4.4
General Control and Status Commands
TTL I/O OUTPUT SETTING
OUT <n> <TTL level>
Sets TTL level on user definable output pin on the ‘TTL I/O’ connector.
<n> Indicates pin number on ‘TTL I/O’ connector
Valid value: 5 (Program Output pin)
Query is not applicable.
TTL INPUT QUERY
IN <n>
Queries TTL level of pin on ‘TTL I/O’ connector. Set is not applicable.
<n> Indicates pin number on ‘TTL I/O’ connector
Valid values: 2, 3, 4, and 6.
Query response: <TTL level>
BUZZER
BUZ [ 0 | { 1 [ < n > ] } ]
Sets / queries buzzer
Set:
0 = Turn buzzer off;
1 = Turn buzzer on
if <n> specified
If <n> = 0, buzzer beeps continuously,
otherwise buzzer beeps <n> times
if <n> not specified, buzzer sounds continuously
Query response: { 0 | 1 }
0 = Buzzer off
1 = Buzzer is on continuously or beeping.