New Era NE-9000 Series Programmable Peristaltic - Manual (Page 62)

New Era Pump Systems Inc.
www.SyringePump.com
Model NE-9000
Publication #1200-04 54
14.2 RS-232 Pump Network Connector Wiring
RS-232
To Network To Computer
PC Com Port Connectors
25 Pin 9 Pin
3 - Receive 2 - Receive Connect to pump TXD
2 - Transmit 3 - Transmit Connect to pump RCV
9 - Ground 5 - Ground Connect to pump GND
14.3 Accessories
14.3.1 ANA-BOX
Part #: ADPT-ANABOX, Analog sensor interface.
Allows the NE-9000 to be controlled by an external sensor, such as a pressure sensor, or other variable
voltage source. Start or stop the pump at a specific voltage level. Set the pumping rate to be proportional
to the voltage input. Creates a closed loop system.
14.3.2 RS-232 Network Cables
RS-232 Network Primary Cable
7 foot cable, part #:
CBL-PC-PUMP-7
25 foot cable, part #: CBL-PC-PUMP-25
Cable to connect a pump, or the first pump in a pump network, to a standard personal computer’s serial
port with a DB-9 or DB-25 connector. Included with this cable is a 9 pin to 25 pin converter.
RS-232 Network Secondary Cable
7 foot cable, part #:
CBL-NET-7
25 foot cable, part #: CBL-NET-25
Cable to connect additional pumps, after the first pump, to the pump network.
USB to RS-232 converter cable
USB to RS-232 cable, software drivers on CD, part#: CBL-USB232
Attached to the RS-232 Network Primary Cable, allows communication through a PC’s USB port.
RCV from network
TXD to network
TXD to computer
RCV from computer