Northern Connectors Harting D-sub Connectors, Housings & Accessories - Manual (Page 147)

05
146
D-Sub
9 09 67 009 043 .
15 09 67 015 043 .
25 09 67 025 043 .
37 09 67 037 043 .
50 09 67 050 043 .
9 09 67 009 053 .
15 09 67 015 053 .
25 09 67 025 053 .
37 09 67 037 053 .
50 09 67 050 053 .
Ø
No. of
Identification contacts Part No. Drawing Dimensions in mm
IP 67 plastic hoods
IP 67 metallized plastic hoods
Hood 1)
Black thermoplastic
Metallized thermo-
plastic
Pressure washer
Mounting
screw
Section A-A
O-ring seal
Rubber gasket
Mounting instructions:
– The peeled back cable braiding must not extend over the cable clamp, in
order not to damage the gasket or to impair its performance.
– Pull back cable until cable clamp snaps into shielding plate.
– Snap connector into hood.
Stripping dimensions
D-Sub
Locking screw,
thread 4-40 UNC þ 8
Locking screw, þ 9
thread M3
Please insert digit
for screw option
a b c d e f g h i
Ø
min. max.
9 20 16.5 13.0 20.2 22.1 36.4 25.0 39.8 18.0 6.0 8.0
15 24 16.5 13.0 20.2 26.6 36.4 33.3 48.5 18.0 6.0 10.5
25 24 20.3 13.0 24.0 26.6 43.6 47.0 62.3 45.0 8.0 12.0
37 24 20.3 13.0 24.0 26.6 52.1 63.5 78.6 60.0 8.0 12.0
50 29 22.0 16.0 27.6 32.1 52.1 61.1 75.7 60.0 9.0 14.0
1) Not to be used with 9 to 50-pole crimp connectors