Northern Connectors Harting D-sub Connectors, Housings & Accessories - Manual (Page 169)

05
168
D-Sub
D-Sub InduCom
66 63 009 5017
66 63 009 5018
InduCom 9 – Industrial bus interface system
Identification Part No. General information
FIP Interface middle of the line
FIP Interface end of the line
The FIP (Factory Installation Protocol) Interface
is specially designed for applications in trains. It is
connected via the D-Sub. The wires are assembled with
the proven vibration resistant cage clamp technology.*
Components of the interface set:
l
1 metal housing with 2 cable entries
l
2 hexagonal screws with UNC 4-40 threads
l
1 pcb with 9 way D-Sub female connector and
cage clamps
The FIP (Factory Installation Protocol) Interface
is specially designed for applications in trains. It is
connected via the D-Sub. On the pcb you will have load
resistors. The wires are assembled with the proven
vibration resistant cage clamp technology.*
Components of the interface set:
l
1 metal housing with 2 cable entries
l
2 hexagonal screws with UNC 4-40 threads
l
1 pcb with 9 way D-Sub female connector and
cage clamps
l
1 blanking piece
Further bus PCBs on request
* To check compatibility with cable types and manufacturers, please contact your local HARTING representative.