Northern Connectors Harting D-sub Connectors, Housings & Accessories - Manual (Page 51)

05
50
D-Sub
D-Sub
The range of pcb connectors available at HARTING is summarised in the table under. For each of the basic
connector versions, the available contact styles are documented with termination process, pitch, plating, rating
for power contacts and impedance for coaxial contact etc..., as well as the accessory configuration.
Pcb connectors are delivered fully loaded thus providing a very good positioning of the contacts in their
cavities for an easy and safe insertion of the pins in the pcb holes particularly crucial in the right angled versions.
Due to the numerous possibilities offered with the pcb connectors, suggested method is to contact your local
HARTING representative to determine the part number to order; see customer request form on pages 05.86
and 05.87.
Connectors for pcb applications – general information
Insulator body
●
Standard
●
SMC: Solder Reflow Compatible
Straight Right angled
●
Standard
●
SMC: Solder Reflow Compatible
Signal contacts
Solder termination
●
Pitch: 2.84 mm
●
Plating: 0.76 µm Au over Ni
●
Pcb thickness from 1.6 to 3.2 mm
Solder termination
●
Pitch: 2.54 mm
●
Plating: 0.76 µm Au over Ni
●
Pcb thickness from 1.6 to 3.2 mm
Power contacts
Solder termination
●
Rating: 20, 30, 40 A
●
Plating: 0.76 µm Au over Ni
Press-in termination
●
Rating: 30 A
●
Plating: 0.76 µm Au over Ni
Solder termination
●
Rating: 20, 30, 40 A
●
Plating: 0.76 µm Au over Ni
Coaxial contacts
Solder termination
●
50 or 75 Ω
●
Plating:
1.3 µm Au over Ni inner conductor
0.76 µm Au over Ni outer ring
Solder termination
●
50 or 75 Ω
●
Plating:
1.3 µm Au over Ni inner conductor
0.76 µm Au over Ni outer ring
Accessories
Through hole
Metal bracket with
board lock and
through hole
Nut:
M3 or UNC 4-40
Metal bracket with
board lock and
clinch nut M3
or UNC 4-40
Spacer:
M3 or UNC 4-40
Metal bracket
with board lock
and female screw
lock UNC 4-40
Spacer
(M3 or UNC 4-40)
with board lock
Spacer
+ board lock
+ female screw lock
M3 or UNC 4-40