Northern Connectors Harting D-sub Connectors, Housings & Accessories - Manual (Page 167)

05
166
D-Sub
66 63 009 5013
66 63 009 5014
D-Sub InduCom
Further bus PCBs on request
* To check compatibility with cable types and manufacturers, please contact your local HARTING representative.
InduCom 9 – Industrial bus interface system
MVB Interface
WTB Interface
Identification Part No. General information
MVB backbone interface set
The Multifunctional Vehicle Bus (MVB) backbone
interface is specially designed for communication
cables in Train Control Networks (TCN). With this
interface it is possible to realise a T-bus structure with
MVB-cable with which you can disconnect the bus
interface from the control unit without any interruption
of the complete bus communication. On the PCB you
will have load resistors and test capacitors which
can be activated with solder bridges. The wires are
terminated with the proven vibration resistant cage
clamp technology.*
Components of the MVB interface set:
●
1 metal housing with 2 cable entries
●
2 hexagonal screws with UNC 4-40 threads
●
1 PCB with 9 way D-Sub male connector and cage
clamps
●
2 crimp flanges for the MVB cable
●
2 crimp ferrules for the MVB cable
●
1 blanking piece
WTB backbone interface set
The Wired Train Bus (WTB) backbone interface
is specially designed for backbone cables in Train
Control Networks (TCN). With this interface it is
possible to realise a T-bus structure with WTB-cable
with which you can disconnect the bus interface from
the control unit without any interruption of the complete
bus communication. On the PCB you will have load
resistors and test capacitors which can be activated
with solder bridges. The wires are terminated with the
proven vibration resistant cage clamp technology.*
Components of the MVB interface set:
●
1 metal housing with 2 cable entries
●
2 hexagonal screws with UNC 4-40 threads
●
1 PCB with 9 way D-Sub male connector and cage
clamps
●
2 crimp flanges for the WTB cable
●
2 crimp ferrules for the WTB cable
●
1 blanking piece