Rockwell Automation 48MS MultiSight Vision Sensor - Manual (Page 19)

MultiSight™ User Manual
Start-up
10000000877(02) 19
To start the MultiSight, proceed as follows:
1. Switch on the power supply (24V DC) for the MultiSight. If necessary, connect the control input (IN2) with V+ (24V DC) (see
note on page 11).
2. For the first start-up of the MultiSight, install the supplied software on the computer that will be used for configuring the
sensor. When the CD is inserted, the installation program starts automatically or can be started using the setup program /
Software/ MultiSight.exe. Then follow the instructions on the screen.
3. During installation, the file MultiSight Sensor Finder.EXE is created (standard folder: C:\Program Files\Rockwell
Automation\MultiSight\…), a link is added to the start menu (standard location: Start\Programs\Rockwell
Automation\MultiSight\…), and an icon is added to the desktop (icon “MultiSight Sensor Finder”). This User Manual can also
be read directly from the CD-ROM (supplied).
4. Configure the network settings according to the instructions in the “Network Settings” section on page 11.
5. Start the PC software by double-clicking the “MultiSight Sensor Finder” icon.
After the installation of the PC software, only one related icon (MultiSight Sensor Finder) is visible on the desktop. Double
click on this icon to open the software which then executes one find loop and shows the list of all MultiSight sensors found on
the local ethernet network. The IP address of the computer is shown at the bottom of the window.
Un-install Procedure
The software can be un-installed by using the operating system
(Windows 2000 and XP™) under Start/Settings/Control Panel/Add
or Remove Programs. Scroll down and select “MultiSight Sensor,”
then click the “Remove” button.