Rockwell Automation 48MS MultiSight Vision Sensor - Manual (Page 31)

MultiSight™ User Manual
Start-up
10000000877(02) 31
Parameter Description Screen Shot
Radio buttons
0…9
(
0…31)
Designates the active detector—by clicking one of the ten radio
buttons, the corresponding detector is selected and its parameters
can be configured. The parameters are displayed in the Detector
Parameters window in the middle of the screen. Only one detector
can be configured at a time. After restart, the most recently
selected detector is active. The selected detector evaluates a
Region of Interest (ROI) which is configured in the Image window.
If a certain detector is to be tested, select that detector and click
the Run command button to the left.
Display icon Checking this box indicates whether the yellow Region of Interest
(ROI) and red pattern frames should be shown on the Image during
Run mode even if the detector is not selected with the radio
button. The Region of Interest (ROI) and pattern frames of the
detector selected with the radio button are automatically
displayed during Run mode; other detectors with a check in the
display icon box are shown but greyed out. This function does not
affect the performance; it is just included to ease the setup process.
Logical link—The time required for execution increases with the
number of logically linked active detectors.
The evaluation with logical linking affects both the primary
inspection pass/fail output OUT1 and the secondary position
result OUT2.
E